Roberts MP-43 Manuál s instrukcemi stáhnout pdf (Strana 11)

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

Using the sound system for the ﬁrst time

1. Place your sound system on a ﬂat surface.

2. Fully extend the telescopic aerial. The aerial should be fully extended

and positioned vertically for optimum reception.

3. Plug the mains lead into the mains socket located on the back of your

sound system ensuring that the plug is pushed fully into the socket.

4. Plug the other end of the mains lead into the wall socket and switch

on the wall socket.

IMPORTANT: The mains plug is used as the means of connecting

the sound system to the mains supply. The mains socket used for the

sound system must remain accessible during normal use. In order to

disconnect the sound system from the mains completely, the mains

plug should be removed from the mains socket outlet completely.

5. When your sound system is ﬁrst switched on the clock display will

show 12:00 and the unit will enter standby mode. It will then scan for

DAB radio stations and when stations have been found the clock and

date should be set automatically. Note that the display will not show

any scanning message for this ﬁrst scan.

6. If no stations have been found then the clock will not set. You may need

to relocate your sound system to a position giving better reception.

You should then carry out an auto-tune to ﬁnd DAB stations. See DAB

Operation on page 10 and also Finding New Stations on page 13. The

clock will then be set from a DAB broadcast.

Introduction .

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Žádné komentáře

Roberts MP-43 Manuál s instrukcemi Strana 11